I have a Winchester M94AE. I would like to add a crescent shaped butt plate to the stock. Is this plausible? I have the skill to do the wood work. Blued steel is preferred.

Thanks for the reply. I was pushing the safety right to left.

On www.gunblast.com, there is an article on how to remove the cross-bolt safety on M94AE's. Only a paper clip is needed. I have tried and tried to do this "simple" procedure, but, alas, cannot get the cross-bar out. Am I missing something? On another thread, I asked for recommendations for...

I need a receiver mounted rear sight to increase the sight radius.

I have the Winchester AE with crossbolt safety in 45LC. The receiver has been drilled and tapped (from factory) on the forward reciver ring and at the back of receiver near the breach block. I want to install after market open sights, front and rear (no peep sights). What would you recommend to buy?...