Winchester Model 94 tang screw thread pitch

[zoner]

Does anybody know what size machine screw and thread pitch Winchester used for tang screws on a mid-1940's Model 94 carbine? so far I know it's not 10/32 and it's not 1/4-20 and seriously doubt it's metric.

[Pat C]

12-28

[zoner]

I should have been more clear......I need diameter and thread pitch for the front screw not the rear one that goes all the way thru to the lower tang. The front screw is smaller in diameter and only about 1/4" long

[Pat C]

3/16-36

[zoner]

I need a plug screw or a set screw for that front hole….iif anyone has one or knows where I can get one I’d appreciate the info……Mike. I’m replacing a Lyman tang sight with a reciever mounted sight and need to plug that front hole

[4t5]

https://homesteadparts.com/shop/tang-up ... p-686.html

[zoner]

ok.....I found and ordered the plug screw I need this morning at Numrich. The first time I looked there I didn't find it but went back today and changed y search inquiry and it came right up. Thanks everyone for helping me out with info. You guys are great!

[Pat C]

Tons of originals on ebay 1894 and 1892 are same. Some of the aftermarket are not correct. Make sure it's correct.