Since my scrounge box had an old slide-adjustable measure for blackpowder, I decided to try my hand
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0333.jpg)
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0335.jpg)
First, I marked out the job
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0336.jpg)
Then I cut the inner half of the measure to length, going by the depth of the INSIDE of the plastic follower, and it's OAL
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0337.jpg)
Into the drill chuck with it, and turn the brass measure's body down to match the OD of the plastic
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0339.jpg)
So far, so good - now it needs to be cut so the OAL matches the plastic
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0340.jpg)
We have separation again !
![Mr. Green :mrgreen:](./images/smilies/icon_mrgreen.gif)
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0341.jpg)
Time to bevel/round the leading edge of the brass copy, and polish out the rough turning marks
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0342.jpg)
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0343.jpg)
![Image](http://i354.photobucket.com/albums/r431/pwawryk/DSCN0345.jpg)
Now to pop it back into the Rossi, to be sure it actually works.
![Wink ;)](./images/smilies/icon_wink.gif)
.