On one end it says "4" and on the other "2", which I assume means .224 and .222.
Now if I want to resize my bullet to .224, do I put it in the hole on that end, or to I have the "4" looking up at me, meaning I've placed the round in the "2" end?
Sorry if I'm confusing you. I've confused myself as well. I used to have the instructions Paco sent, but I can't seem to find them.
Question About Paco Tool
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Re: Question About Paco Tool
You stick the cartridge in the end marked with that number.
Sincerely,
Hobie
"We are all travelers in the wilderness of this world, and the best that we find in our travels is an honest friend." Robert Louis Stevenson
Hobie
"We are all travelers in the wilderness of this world, and the best that we find in our travels is an honest friend." Robert Louis Stevenson
Re: Question About Paco Tool
Thanks for the quick reply!