Powder storage question

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
fatoldfool
Levergunner 2.0
Posts: 163
Joined: Sat Jul 25, 2009 4:37 pm

Powder storage question

Post by fatoldfool »

Howdy fellas, lot of changes in my life in the past year and a half. Thinking about buying a storage building (wood framed, T111 sided) and moving my reloading stuff from the basement to the unheated building. If I use an old freezer for powder storage will my powder be OK? including black powder? Temps here range from 10 below zero to occasionally over 100 degrees F....
3leggedturtle
Advanced Levergunner
Posts: 4145
Joined: Fri Dec 21, 2007 11:34 am
Location: north of Palacios about 1400 miles

Re: Powder storage question

Post by 3leggedturtle »

I,ve kept powder in an unheated garage for last 15 years and never had a problem with them. Keep the cap on tight when not reloading, should be ok.
30/30 Winchester: Not accurate enough fer varmints, barely adequate for small deer; BUT In a 10" to 14" barrelled pistol; is good for moose/elk to 200 yards; ground squirrels to 300 metres

250 Savage... its what the 223 wishes it could be...!
User avatar
COSteve
Advanced Levergunner
Posts: 4093
Joined: Sun Jul 12, 2009 4:03 pm
Location: A little valley up in the Rockies

Re: Powder storage question

Post by COSteve »

Allowing the powder to temp cycle certainly isn't the best idea if you don't have to. In addition, if you live where it's humid you're adding another variable to degrading powder life as well as increasing your chances of your reloading equipment rusting.
Steve
18 Years into My New Career; 'Gentleman at Leisure'
No Matter Where You Go, There You Are
User avatar
AJMD429
Posting leader...
Posts: 33589
Joined: Sun Sep 09, 2007 10:03 am
Location: Hoosierland

Re: Powder storage question

Post by AJMD429 »

What about an insulated container (plywood box with styrofoam lining, old freezer or fridge) - plus a small amount of heat in the extreme cold. Theoretically a pipe-heating cable might even be enough, and be safe unless it really malfunctioned, OR if your powder were within a picnic-cooler type thing, and THAT thing was in a plywood box twice as big, and you kept a 75 watt light-bulb on inside that cabinet, it would stay pretty warm vs. 'outside' temps.
It's 2025 - "Cutesy Time is OVER....!" [Dan Bongino]
Don McDowell

Re: Powder storage question

Post by Don McDowell »

Any blackpowder you stored that way would be fine, but the smokeless powder might not take it to well over an extended time, and the primers may absorb more moisture than you'ld like them to.
stretch
Advanced Levergunner
Posts: 2374
Joined: Wed Oct 03, 2007 7:15 pm

Re: Powder storage question

Post by stretch »

A goldenrod heater might help temps in the winter.

I've got some OLD (Herter's!) SRP that were stored
in a damp basement long ago. They work just fine,
and I'm pretty sure they're older than I am.

My limited experience says you'll be all right, but
there's no denying the temp cycles won't do the
powder any actual good.

-Stretch
Post Reply