tang sight problem

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
big bear
Levergunner 2.0
Posts: 499
Joined: Sun Sep 23, 2007 10:56 am

tang sight problem

Post by big bear »

Put a Marbles tang sight on a browning 65, now the lever is really really stiff to operate? What's wrong?
Top
SJPrice
Levergunner 3.0
Posts: 722
Joined: Fri Sep 21, 2007 8:20 pm
Location: Texas

Re: tang sight problem

Post by SJPrice »

How much did you torque the tang screw?
Always Drink Upstream From The Herd
Top
big bear
Levergunner 2.0
Posts: 499
Joined: Sun Sep 23, 2007 10:56 am

Re: tang sight problem

Post by big bear »

SJPrice wrote:How much did you torque the tang screw?
Gunsmith did it for me as Iwanted rifle checked out.Shouls I just loosen the two screws a wee bit, one at a time?
Top
jnyork
Advanced Levergunner
Posts: 4443
Joined: Wed Sep 12, 2007 12:33 pm
Location: Wyoming and Arizona

Re: tang sight problem

Post by jnyork »

big bear wrote:
SJPrice wrote:How much did you torque the tang screw?
Gunsmith did it for me as Iwanted rifle checked out.Shouls I just loosen the two screws a wee bit, one at a time?
Yes. Also, there is a chance one of the screws is too long and binding something up.
Top
Post Reply

Return to “General Discussion”