LYMAN MODEL 56 RECEIVER SIGHT
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
LYMAN MODEL 56 RECEIVER SIGHT
On my Marlin 39A, I have Lyman's 56 sight. Is this sight designed and intended to remove/replace its horizontal bar? I ask because I want to mount a scope with Warne steel detachable mount/rings assembly. If remove/replace Lyman 56's horizontal bar will not harm its zero or harm the sight's longevity, I want to keep it affixed — that is, base affixed permanently; horizontal bar in a pocket on the sling.
It's so simple to be wise. Just think of something stupid to say and then don't say it. Sam Levinson
-
- Advanced Levergunner
- Posts: 4145
- Joined: Fri Dec 21, 2007 11:34 am
- Location: north of Palacios about 1400 miles
Re: LYMAN MODEL 56 RECEIVER SIGHT
They are supposed to return to zero. The side has a 0 on it for when sighted it in so you can put it back to that spot.
30/30 Winchester: Not accurate enough fer varmints, barely adequate for small deer; BUT In a 10" to 14" barrelled pistol; is good for moose/elk to 200 yards; ground squirrels to 300 metres
250 Savage... its what the 223 wishes it could be...!
250 Savage... its what the 223 wishes it could be...!