Heavy bullet mold for 357 Mag.

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
Yance
Levergunner 2.0
Posts: 143
Joined: Fri Sep 07, 2007 10:05 pm

Re: Heavy bullet mold for 357 Mag.

Post by Yance »

Rifle or revolver?

Rifle/carbine a good 180-200 gr WFN design, preferably a GC version. Dan at Mountain Molds
http://mountainmolds.com cuts a really nice mold and will bend over backwards to make sure you're satisfied with his product.

Revolver, Lyman's 385429 170 gr Keith wold be good. Without changing out rear sight blades on my long barreled N frames that's about as heavy as I can go. Tried a 205 gr that my buddy designed but the best I cold do was still about 6" high at 25 yd.
Yance

There's a fine line between "Hobby" and "Mental Illness".

outawaysforge.wordpress.com

"Gun control" isn't about guns, it's about "control".
Post Reply