Button Style Safety Replacement Plug

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
rossim92
Senior Levergunner
Posts: 1433
Joined: Sat Jan 01, 2011 2:42 am
Location: mechanicsville, md.

Button Style Safety Replacement Plug

Post by rossim92 »

just replaced the plastic mag follower for a ss one in my rossim92. Now thinking of replacing the swivel safety with a plug. I've noticed it has a very, very tiny pin holding it in. Has anybody replaced one of these? If so, did you have good/bad luck trying to drift the pin? any advice, thanks
Rossi 92 .357 lever , and a cz pcr 9mm
Henry .22 lever, Remington speedmaster 552 .22 lr
Marlin Glenfield .22 boltaction
gforce 12ga semi
Taylor's Tactical 1911 A1 FS in .45acp
winchester 1873 44.40
Marlin 336W .30.30
beeman sportsman rs2 dual caliber pellet rifle
henry .22 magnum pumpaction/octagon barrel
stag 5.56 m4 with reddot
Top
User avatar
earlmck
Advanced Levergunner
Posts: 3450
Joined: Tue Nov 30, 2010 12:10 am
Location: pert-neer middle of Oregon

Re: Button Style Safety Replacement Plug

Post by earlmck »

Drifts out easy, left to right. I don't have a bunch of nice punches to choose from: the primer-punch from one of my loading dies worked just fine. I replaced mine and one for a buddy with Steve's peep sights but the blank should go in just the same.
The greatest patriot...
is he who heals the most gullies. Patrick Henry
Top
Post Reply

Return to “General Discussion”