The fun has begun

wvfarrier · Post by **wvfarrier** » Fri Aug 19, 2022 9:24 am

I decided to build a revolver to my own specs.

The barrel is a 4" 357 mag that was never mounted. I sent it to Magnaport to be quad ported and crowned. Its now on its way to Tenring Precision to have the front sight milled out to accept the newer interchangable blades. Then itll be mounted on this performance center 627.

Prior to sending it all to TenRing I did a super nice action tune (DA Trigger pull is just over 5#), installed the TK CUSTOM target hammer and extended cylinder release.

Once I get it back it will be headed off to be Black DLC coated.

Tycer · Post by **Tycer** » Fri Aug 19, 2022 9:28 am

Nice project. Really looking forward to hearing updates and seeing range reports!
Is it possible to have the lawyer safety hole filled before coating?

wvfarrier · Post by **wvfarrier** » Fri Aug 19, 2022 10:01 am

I actually thought about it but I worry about the legal ramifications should I ever use it in a self defense scenario

Grizz · Post by **Grizz** » Fri Aug 19, 2022 11:14 am

that's Stunning. . and an inspiration too.

Streetstar · Post by **Streetstar** » Sat Aug 20, 2022 10:25 pm

wvfarrier wrote: ↑Fri Aug 19, 2022 10:01 am I actually thought about it but I worry about the legal ramifications should I ever use it in a self defense scenario

Versus other ramifications of a SD scenario?

Your choice of firearm will probably not matter much , especially if a revolver.

wvfarrier · Post by **wvfarrier** » Sun Aug 21, 2022 5:10 pm

More along the lines of "deactivsting" a safety mechanism

4t5 · Post by **4t5** » Sun Aug 21, 2022 5:32 pm

might be a problem if some one got hurt USING your revolver.

The fun has begun

The fun has begun

Re: The fun has begun

Re: The fun has begun

Re: The fun has begun

Re: The fun has begun

Re: The fun has begun

Re: The fun has begun