Thanks for all the info. Have done a few things since my last post. Spent several hours reading through the castboolits site. Great info and gave me a lot more information... probably too much. Will need to focus on one thing at a time so I can make sure what I do is measurable / repeatable etc. I m...

Have been looking diligently for load data for cast bullets using N110 for the .41 magnum. The only information I seem to be able to find is for jacketed bullets. I am looking to reload 215 grain poly coated bullets by gallant for my Henry big boy. Looking for a solid plinking load as well as a sugg...

So, took a good look down the barrel and it definitely has some build up. Gave it a thorough cleaning but I can still see a good bit of build up in the rifling. Looked up and watched a couple video's on cleaning lead out of the bore. Anyone use copper wool? Also pulled a bullet from one of my dad's ...

I will look at both these suggestions. I should probably check for leading too. My dads lswc probably aren't gas checks or poly coated. He was highly likely to have loaded hot rounds too. I don't have a chrono to check but pulling a bullet and looking at the powder and its weight may give me a good ...

Thanks for the info so far all. Curious for those of you loading cast bullets, if any of you have loaded with VV N110? If I use H110 I am going to have to go on a trade mission. I do however have 3lbs of N110 but can not find any load data using it with cast bullets. I have a 215gr poly coated swc t...

Thanks for the info. I have to admit I haven't seen the lyman cast manual. I will look it up and see what info I can find. I have only ran a few jacketed bullets through the Henry so far. The reloaded swc's I have of my dad's are shooting amazingly flat. Kind of why I looked into the lswc's for relo...

Hello all, I am looking for some reloading help in regards to my Henry 41 magnum. I have reloaded some 210 grain moly coated lswc cast bullets and have had an issue getting them to group at 25yards. I did three separate loads using hp38 powder at 6.6, 6.9 and 7.4 grains. 5 rounds of each and my grou...