replacement hammer pin in 39-A

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
ol'e cowboy
Levergunner
Posts: 1
Joined: Sun Jan 25, 2009 12:52 am

replacement hammer pin in 39-A

Post by ol'e cowboy »

THE REPLACEMENT HAMMER PIN ,,,,,,,WILL THE SAME PIN THAT WORKS FOR THE 336-C WORK FOR THE 39-A,,,,THE ACTION IS MUCH THINER,??????? MY 39-A IS A NEWER ONE
Last edited by ol'e cowboy on Tue Jan 27, 2009 11:21 pm, edited 1 time in total.
Top
Jaguarundi
Senior Levergunner
Posts: 1804
Joined: Tue Feb 19, 2008 3:27 am
Location: Wiregrass Area,Alabama

Re: replacement hammer pin in 39-A

Post by Jaguarundi »

BTT :) Maybe.Better off getting a replacement pin.Welcome aboard.
"Those who hammer their guns into plows will plow for those who do not."
Top
Leverdude
Senior Levergunner
Posts: 1518
Joined: Tue Apr 03, 2007 6:25 pm
Location: Norwalk CT

Re: replacement hammer pin in 39-A

Post by Leverdude »

ol'e cowboy wrote:THE REPLACEMENT HAMMER PIN ,,,,,,,WILL THE SAME PIN THAT WORKS FOR THE 336-C WORK FOR THE 39-A,,,,THE ACTION IS MUCH THINER,???????

Yup. Might be a tad long, but theyre sometimes a tad long for a 336 hammer, just file it flush. The hammers are the same thickness on the pre saftey ones. The newer ones I'm not sure.
Last edited by Leverdude on Tue Jan 27, 2009 9:56 am, edited 1 time in total.
Top
jdad
Advanced Levergunner
Posts: 3446
Joined: Fri Sep 07, 2007 7:55 am
Location: Oregon

Re: replacement hammer pin in 39-A

Post by jdad »

This depends on hold old your 39A is.
I know a whole lot about very little and nothing about a whole lot.
Top
Post Reply

Return to “General Discussion”