Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
It needs a screw hole drilled through it's front tongue & one hole D/T'd in the top-center of the scope groove area.
It has a small elevation adjustment, and a sliding gib-locked windage adjustment - and just about lines up with the issue sights on my Henry H001 levergun, when it's in the full down position.
Ah, these are made as an insert for 96 Swedish Mauser rear sight, I recently installed one on my son's 1916 (93) Spanish Mauser though it took some fitting BIG improvement especially in windage adjustment over the military site (no windage), and dropped the elevation to hit right on at 50 yards (military sights a foot high at 50).
Inventive adaption I must say on your part Pete.
I went a different route on my Marlin 39.
Used Winchester 96 rear peep in barrel dovetail.
KI6WZU
NRA member
"When they call the roll in the Senate, the Senators do not know whether to answer 'present' or 'not guilty.'"
--President Theodore Roosevelt (1858-1919)
“Democracy must be something more than two wolves and a sheep voting on what to have for dinner”
