have to shorten mag tube

Welcome to the Leverguns.Com Forum. This is a high-class place so act respectable. We discuss most anything here ... politely.

Moderators: AmBraCol, Hobie

Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.

Please post political post in the new Politics forum.
Post Reply
dbateman
Levergunner 2.0
Posts: 372
Joined: Mon Dec 10, 2007 7:46 am
Location: Mt Isa QLD Australia

have to shorten mag tube

Post by dbateman »

i have to shorten my magazine tube on my 9422
on the inside mag tube to remove the nurled knob
do you just drift the pin out ?
or is there a better way to do it?
Image
Top
User avatar
meanc
Levergunner 3.0
Posts: 902
Joined: Mon Apr 09, 2007 5:01 pm
Location: Fl

Post by meanc »

Just drift the pin and it'll come right off. Just make sure to punch the exposed end back thru the tube.
...and I don't think he even knows it...Walks around with a half-assed grin...If he feels fear, he don't show it. Just rides into hell and back again.
Top
dbateman
Levergunner 2.0
Posts: 372
Joined: Mon Dec 10, 2007 7:46 am
Location: Mt Isa QLD Australia

Post by dbateman »

thanks meanc
Top
KCSO
Levergunner 3.0
Posts: 780
Joined: Wed May 14, 2008 3:57 pm
Location: North East Nebraska

Post by KCSO »

I slammed mine in the car door and it shortended right up.
Top
mescalero1
Advanced Levergunner
Posts: 4923
Joined: Sat Dec 22, 2007 1:08 am
Location: Arizona headed for New Mexico

Post by mescalero1 »

Ouch!
Top
Post Reply

Return to “General Discussion”