Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
I am seriously considering mounting a scope on a pre-AE Model 94. This mount looks pretty good in that no additional holes need to be drilled.
Anyone used one?
Any views on side mounts in general?
Kwik-Site 94 Winchester Side Mounts "This patented innovative scope mount is specifically designed for the popular Winchester 94. It features an unique, patented adjustable windage bushing for accurate, precise scope alignment. Mounts in minutes to the side of the receiver utilizing existing factory drilled and tapped holes. Rings and support are precision machined for a tight, snug mounting of most popular scopes to the Model 94 lever action rifle."
Last edited by Bruce Scott on Tue May 20, 2008 5:18 am, edited 1 time in total.
I have a B-Square on two long barrel Pumas (44 mag and 357 mag) and like them. Both I've used short, light scopes on, because the torque could be great with a long or heavy one. No problems with a 4x 20mm or a Barska 3-9 IR compact, though.
Ejection hasn't been a problem with these particular guns - the brass still flies over your right shoulder and hits whoever is behind you!
Strange to get the crosshairs level (they always seem tilted to me when they aren't), but once you get it done you get used to them off to the side.
Accuracy is fine, and they work with tang sights on the gun and vice versa.
I've only dismounted and remounted one, but zero was not detectably changed at 100 yards (judging by 95% 6" gong hits).
Last edited by AJMD429 on Mon May 19, 2008 8:25 pm, edited 2 times in total.
It's 2025 - "Cutesy Time is OVER....!" [Dan Bongino]
