Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Karma give away. If you need any of this stuff, let me know what number you want via a PM with your mailing address, post "i'll take it" here also to avoid conflicts and it is yours. I'll mail it in padded envelopes asap.
All new in wrapping, you should be able to read the sizes if not let me know.
Used with the a #1, to center the flash hole reamer into the case mouth. This one is for a 6mm. You would need the handle and reamer (see #1) then you slide and use a set screw to tighten the pilot onto the reamer. The reamer is used to clean out and round out the primer flash hole inside the brass case to insure consistent and uniform ignition of the powder from the primer.