Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Slings: Is there a single-point option out there? If not, what did you use? I'm not opposed to the thought of one of the ballistic nylon quivers out there, either. Anyone use those?
Stock: I've read here that the Ramline takes a lot of effort to fit. Are there replacement wood units available at a reasonable price? I love the 12.5" LOP at the center of the butt, but...I'd like a flat plate, or a hard rubber pad for more grip on my clothing.
Sight: I'm debating the safety replacement from NKJ, vs one of the peeps that replaces the stock rear sight. However, I'm one of the weirdos that's none too bothered over the safety, and I would actually use it if I had to empty the mag for whatever reason. Over 40 eyes, and near-sighted, I tend to look OVER my lenses when shooting my handguns.
Go with a Williams FP or something similar if you are intent on keeping the "safety".
C2N14... because life is not energetic enough. מנא, מנא, תקל, ופרסין Daniel 5:25-28... Got 7.62?
Not Depressed enough yet? Go read National Geographic, July 1976 Gott und Gewehr mit uns!
pneuby wrote:I shoot LH, so it just didn't seem workable to me. However, can a saddle ring be installed from the RH side of the gun?
That's a question for Steve....
HEY NKJ! OVER HERE!
C2N14... because life is not energetic enough. מנא, מנא, תקל, ופרסין Daniel 5:25-28... Got 7.62?
Not Depressed enough yet? Go read National Geographic, July 1976 Gott und Gewehr mit uns!
pneuby wrote:I shoot LH, so it just didn't seem workable to me. However, can a saddle ring be installed from the RH side of the gun?
They do make a single-point sling attachment that attaches to any standard scope rail, if you wanted to put a short (1" would do) section somewhere on the gun, i.e. by replacing a tang or action screw with a longer one or something.
Doctors for Sensible Gun Laws "first do no harm" - gun control LAWS lead to far more deaths than 'easy access' ever could.
pneuby wrote:I shoot LH, so it just didn't seem workable to me. However, can a saddle ring be installed from the RH side of the gun?
That's a question for Steve....
HEY NKJ! OVER HERE!
Sure, but it would need to be one of the later stud type saddlerings. For two reasons, the staple type that was used on the original 92 is hard to come by and second the stud type only requires one D&T-ed hole. The 92 receiver can be D&T-ed on the right side directly across from where it would be on the left side.