model 94 winchester
Forum rules
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
Welcome to the Leverguns.Com General Discussions Forum. This is a high-class place so act respectable. We discuss most anything here other than politics... politely.
Please post political post in the new Politics forum.
model 94 winchester
My barrel bands screw are buggered and I cannot get them off. If I buy gunsmithing screwdrivers will they work then? Any suggestions? Thanks
Re: model 94 winchester
Put some penetrating oil on them and take a drift punch with the flat end about screw size and tap the upset metal back in place so it resembles a screw again. This will also help loosen them. Get a good fitting driver and try again. Don't just try turning them, kind of bump them if that makes sense.
- J Miller
- Member Emeritus
- Posts: 14885
- Joined: Sat Mar 31, 2007 7:46 pm
- Location: Not in IL no more ... :)
Re: model 94 winchester
Kings,
Welcome to the forum.
I agree with what Marvin said. I'd also add that the threads on those screws are incredibly fine and they can get extremely tight.
It gets worse if they've got a bit of rust in there too.
Joe
Welcome to the forum.
I agree with what Marvin said. I'd also add that the threads on those screws are incredibly fine and they can get extremely tight.
It gets worse if they've got a bit of rust in there too.
Joe
***Be sneaky, get closer, bust the cap on him when you can put the ball where it counts .***